CARE POINT
Laser Welder Settings
Press Memory button ‘MEM’ ONCE only – Arrow will point left for 3 seconds only, during which time +/- can be used to select required program.
Arrow pointing left.
DO NOT ATTEMPT TO CHANGE PROGRAM IF ARROW IS POINTING TO THE RIGHT
(this may accidentally rename the program!).
Preset Memory2 M2 is for 2.4mm springs
Preset Memory3 M3 is for 3.2mm springs
Preset Memory4 M4 is for 4.0mm springs
Preset Memory5 M5 is for 4.8mm springs
THESE SETTINGS MUST NOT BE ALTERED
IF THEY DO NOT APPEAR AS ABOVE INFORM SUPERVISION IMMEDIATELY
Back to top
CARE POINT: 04/01/2013
